DIY Expanded Metal Lath Installation II - Anping Huihe Hardware And Wire Mesh CO., ltd.

blog

DIY Expanded Metal Lath Installation II

According to the first article DIY Expanded Metal Lath Installation I, we can know a lot of preparations. But it is not the whole steps, you should do a lot for the next steps.

Expanded Metal Lath includes a diamond shaped mesh. To be able to type a correct holding base for stucco or plaster, the pockets formed by the mesh ought to face upward. The mesh ought to really feel rough in the event you run your hand downward across it and smooth when operating your hand upward.

Attach the Expanded Metal Lath to wood framing with 1-1/2-inch roofing nails. Nails ought to be 16 inches on center with no much more than a six inch vertical spacing. When attaching lath to wood sheathing, 1-1/2 inch staples having a 3/4-inch crown ought to be utilized.

Expanded Metal Lath ought to be wire-tied at nine-inch intervals on edge and finish laps to stop separations.

To be able to permit the plaster or stucco to correctly adhere towards the Expanded Metal Lath, a minimum 1/4-inch gap ought to be maintained in between the lath and also the surface with the wall.

Lath could be cut to size and shaped with shears. A regular circular saw having a metal cutting blade can decrease cutting time on a bigger job. Usually use eye and hearing protection when cutting metal with energy tools to stop severe injury.

Pre Page: Historically Meaning of Concertina Wire... Next Page: DIY Expanded Metal Lath Installation I

Product (55)

Special Groups (8)

blog (13)

Credit Report

Products Index

Company Info

blog