DIY Expanded Metal Lath Installation I - Anping Huihe Hardware And Wire Mesh CO., ltd.

blog

DIY Expanded Metal Lath Installation I

Whether or not you'd like a stucco finish in your home or you have usually fancied a stone facade, installing Expanded Metal Lath is going to be your initial step. As with any other finishing job, the very first actions are probably the most essential to achieving satisfactory outcomes.

Preparation

Prior to the Expanded Metal Lath is installed, a moisture-proof barrier should be applied to wood sheathing. This barrier prevents wood decay that would otherwise create throughout the application of wet plaster or concrete. Examine your nearby creating codes for acceptable kinds of barrier materials and their technique of application.

Initial Actions

Following the moisture barrier is in location, install all corner beads, weep edges, casing beads and expansion joints. Lath accessories like beads and edges ought to be nailed or stapled a minimum of each and every 18 inches. If you're not utilizing self-furring Expanded Metal Lath, furring strips ought to be nailed in location following all accessory pieces are in location.

Hanging Expanded Metal Lath

Expanded Metal Lath ought to be hung horizontally. Joints in between panels ought to be staggered inside a regular brick-laying pattern. The seam in between the very first and second panels on the bottom with the wall ought to fall within the center with the panel placed instantly above them.

Pre Page: DIY Expanded Metal Lath Installation II Next Page: Development of Concertina Wire

Product (55)

Special Groups (8)

blog (13)

Credit Report

Products Index

Company Info

blog